® Copyright TeleMatrix Inc 20083302TRM2 LINE TRIMLINEUSERS GUIDETELEPHONE SET
INSTALLATIONConnecting The Handset CordPlug one end of the modular coiled handsetcord into the receptacle located on the leftside of the base unit. Pl
The TeleMatrix Trimline telephone can be wall mounted to a standard telephone wall jack plate. Using the 3.5-inch line cord, plug one end into the rec
INSTALLATIONHandset Retaining ClipThe handset retaining clip must be activated tohold the handset when wall mounting thetelephone. Turn the “wall moun
SWITCH SETTINGSFlash SwitchThere is a 3-position slide switch located onthe handset under the plastic cover. Use a sharp pointerto remove the switch p
SWITCH SETTINGSRinger Volume Control SwitchThere are two (2) slide switches located on the leftside of the base unit that is used to adjust the loudne
SWITCH SETTINGSMessage Waiting SwitchThere are two (2) slide switches located on thebase unit under a plastic cover. Use a sharp pointer to removethe
OPERATIONA. Line Status IndicatorsThe 2-line TrimLine is equipped with LEDindicators to show the current status of thetelephone lines. They are : Ri
CARE & MAINTENANCEKeep the telephone dry. If it gets wet on the out-side, wipe it dry immediately. Liquids might con-tain minerals that can corrod
SERVICE INFORMATIONWhen problems arise during installation or service thatcannot be resolved using this or related documents, contactyour regional Tel
FCC REQUIREMENTS1. The Federal Communications Commission (FCC) has estab-lished Rules which permit this device to be directly connected tothe telephon
INTRODUCTIONCongratulations on the purchase of yourTeleMatrix 2-line Trimline telephone.This telephone is a precision electronicdevice designed and ma
WARRANTY19STATEMENT OF LIMITED WARRANTY INCLUDING, WITHOUT LIMITATION, DAMAGES OF LOST PROFITS, LOST REVENUES, LOSS OF USE OF FACILITIES OR EQUIP
CONTENTSTable Of ContentsIntroductionFeaturesControlsDefinition Of ControlsInstallationParts ChecklistWall Mounting13456710Switch Setting 12Operation1
FEATURESTwo Line OperationTone DialingMessage Waiting LampConvenient Data PortHold KeyLine Status Indicat
CONTROLS4
DEFINITION OF CONTROLS1. Data PortUsed for plugging in a laptop, modem, fax, etc.2. Redial keyUsed to automatically redial the last number dial.3.Flas
INSTALLATIONCautionNever install telephone wiring during a lightningstorm.Never install telephone jacks in wet locationunless the jack
1. 15’/4.5mlinecordsoldseperately2. RJ11C/WLineCord-3.5/.09m3. HandsetCoilCord-10’/3.05m
INSTALLATIONConnecting The Line CordPlug one end of the 15-foot modular telephoneline cord into the receptacle on the bottom ofthe base unit. Route th
Kommentare zu diesen Handbüchern